Posts Tagged ‘cleaning your motorcycle helmet’

Your motorcycle helmet is your most important piece of equipment so keeping it clean is important.  Not just from an appearance perspective but as a method to ensure it is still in good working condition. Also, April is Motorcycle Helmet Awareness month so now is a good time to do the work!

While you are cleaning your helmet look for cracks in the shell, that the hard foam is intact and in good condition (this is the part that does most of the work to protect your head) and all the other parts are in good order.  

Before you start… read your owner’s manual on cleaning your specific motorcycle helmet.

1 – First thing is to clean the exterior of the motorcycle helmet. Using a wet microfiber cloth or a paper towel, lay it across the visor and helmet shell for at least 10 minutes. This will soften the baked-on bugs and cruds allowing them to be wiped away reducing the chance to scratch or damage the finish. You may have to repeat this step.

2 – Remove the visor after you have cleaned the exterior. Use warm soapy water to really get the visor clean inside and out. Rinse, dry and reassemble your helmet.

3 – The visor needs special attention. DO NOT use any products that have acid or ammonia!  Even products with citric acid can damage the visor.  Most glass cleaners have some form of acid or ammonia so pay close attention or just avoid them. Warm soapy water and microfiber cloth is the best way to safely clean your visor.

4 – Make sure you clean the visor mechanism.  Keeping the mechanism clean will ensure it works as designed.

5 – Does your helmet have a sun visor?  If it does clean it in the same manner, you cleaned the visor.  No ammonia or acid-based cleaners!

6 – Next up is the interior of your motorcycle helmet.  Most helmets allow you to remove the interior padding. Look at your owner’s manual for directions on removing the padding. Some manufactures allow you to use a washing machine and other recommend hand cleaning in warm soapy water.  If you use the hand method, I recommend using a baby shampoo.

7 – If your helmet’s padding is not removable follow the instructions your helmet manufacture provides. But, in my opinion, dunking the entire helmet into soapy water is not the way to go.  It takes forever to dry; it can mildew, and I am always unsure if it can damage the underlying foam.  My suggestion is to use a motorcycle helmet sanitizing spray.

8 – Check the air vents to make sure they are clean, and function as designed. A shot of compressed air, from the inside, might dislodge dried road grime and bugs.

9 – Put it back together, following the manufacturer’s instructions, if you still have them.

Ride on, Ride safe